Swansboro Port Realty Reviews (5)
View Photos
Swansboro Port Realty Rating
Address: 626 W Corbett Ave, Swansboro, North Carolina, United States, 28584
Phone: |
Show more...
|
Web: |
|
Add contact information for Swansboro Port Realty
Add new contacts
ADVERTISEMENT
I installed attic foil in my house in early summer The joke in my house was the air conditioning comes on in the spring and goes off in the fall, literally it would come on around or in the morning and run constant til midnight then intermittently til in the morning and stopSince attic foil was installed now it comes on average around two to three in the afternoon and intermittently til about at night I would estimate my havac system runs less than half Which I assume will increase its life expectancy and I believe I save at least to dollars a monthHard to tell with temperature and kWh increases but very happy with this product
Excellent customer service Spoke to owner prior to purchase Product delivered timely, no damageThe product material is very tough, and of a high quality Installation in my type of attic (many low trusses, with deep, shallow areas) was a difficult endeavor BUT, it turned out to be well worth itThe inland valley area of So Cal is a boiler! Installed during the hottest part of the summer, we noticed an immediate drop in inside temperature during the hottest parts of the day Same with the garage Probably one of the least expensive of all home improvement upgrades we have invested in Recommend to all
Thanks to the excellent installation videos on your website, I was able to install AtticFoil in my hip-roof attic although I had no helper and I'm years oldIt took me a little longer, but I got it done! Because of the joist in my attic, I used your 26-inch product and stapled it vertically to the raftersI took the measurements, cut the pieces, and rolled them up individually and placed them under the rafter to which they would later be attached I didn't have help cutting the pieces either, so I made a stand for the foil rolls out of two cinder blocks and a broom stickThen I measured out the correct distance from my cutting board and marked it with a strip of duct tape I would roll out each piece to the edge of the tape, place the duct tape roll on top to hold it in place, go back and cut the piece along the edge of the board, and then roll up the strip I was able to get about half of the east side of my attic done the first dayThe next day, when we had unseasonably warm temperatures here, I noticed a huge difference in the temperatures between the section of the attic I had completed and the section that I was working on You are right! Going into the finished section of the attic was like going into the shade out of the direct sunThis should make a big difference
Received great advice on which foil to purchase for my project very pleased! Fast shipping highly recommend
Everything about this transaction was great shipping,product, to saving money because it did make my second floor cooler in the summertime thank you atticfoil